Always On Call, Always The Right Call
 
Call H & N Plumbing, Heating, & Electrical, Inc. for reliable Furnace replacement in Fennimore WI.
 
Serving Southwest Wisconsin
 
H & N Plumbing, Heating, & Electrical, Inc. has certified technicians to take care of your Furnace installation near Boscobel WI.
 

Electrical Conversions & Definitions

Electric Conversions

Electricity Conversion/Equivalency Charts & Definitions

Unit-of-Measure Equivalents

Unit Equivalent
Kilowatt (kW) 1,000 (One Thousand) Watts
Megawatt (MW) 1,000,000 (One Million) Watts
Gigawatt (GW) 1,000,000,000 (One Billion) Watts
Terawatt (TW) 1,000,000,000,000 (One Trillion) Watts
Gigawatt 1,000,000 (One Million) Kilowatts
Thousand Gigawatts 1,000,000,000 (One Billion) Kilowatts
Kilowatthours (kWh) 1,000 (One Thousand) Watthours
Megawatthours (MWh) 1,000,000 (One Million) Watthours
Gigawatthours (GWh) 1,000,000,000 One Billion) Watthours
Terawatthours (TWh) 1,000,000,000,000 (One Trillion) Watthours
Gigawatthours 1,000,000 (One Million) Kilowatthours
Thousand Gigawatthours 1,000,000,000 (One Billion) Kilowatthours
U.S. Dollar 1,000 (One Thousand) Mills
U.S. Cent 10 (Ten) Mills
Source: Energy Information Administration, Office of Coal, Nuclear, Electric and Alternate Fuels, Electric Power Division.

In order to convert from U.S. units to metric units using the conversion factors shown in the following table, multiply the number of U.S. units (e.g., 2 pounds) times the conversion factor shown (0.45359237) to obtain the equivalent number in metric units (2 pounds times 0.45359237 pounds/kilograms = 0.90718474 kilograms)

Metric Conversion

Mass

1 short ton (2,000 lb) = 0.9071847 metric tons (t)

1 pounds (lb) = 0.45359237a kilograms (kg)


Volume

1 barrel of oil (bbl) = 0.1589873 cubic meters (m3)

1 cubic foot (ft3) = 0.02831685 cubic meters (m3)

1 U.S. gallon (gal) = 3.785412 = liters (L)


Energy

1 British thermal unit (Btu) = 1,055.055 852 62ab joules (J)


aExact conversion.
bThe Btu used in this table is the International Table Btu adopted by the Fifth International Conference on Properties of Steam, London, 1956.
Notes: Spaces have been inserted after every third digit to the right of the decimal for ease of reading. Most metric units belong to the International System of Units (SI), and the liter and metric ton are acceptable for use with the SI units.
Sources: General Services Administration, Federal Standard 376B, Preferred Metric Units for General Use by the Federal Government (Washington, DC, January 27, 1993), pp. 9-11, 13, and 16. National Institute of Standards and Technology, Special Publications 330, 811, and 814. American National Standards Institute/Institute of Electrical and Electronic Engineers, SVIEEE Std 268-1992, pp. 28 and 29.

Useful Electricity Terms
  • A Btu or British Thermal Unit is a standard unit for measuring the quantity of heat energy equal to the quantity of heat required to raise the temperature of 1 pound (16 ounces) of water by 1 degree Fahrenheit.
  • The Capacity Factor of a generating unit is the ratio of "the electrical energy produced by a generating unit for a given period of time" to "the electrical energy that could have been produced at continuous full-power operation during the same period."
  • Efficiency is derived by dividing the heat content of 1 kilowatthour of electricity (3,412 Btu per kilowatthour) by the number of Btu contained in the input used to produce 1 kilowatthour.
  • Energy is the capacity for doing work--as measured by the capability of doing work (potential energy) or the conversion of this capability to motion (kinetic energy). Energy has several forms, some of which can be converted into another form useful for work. Most of the world's convertible energy comes from fossil fuels that are burned to produce heat that is then used as a transfer medium to mechanical or other means in order accomplish tasks. Electrical energy is usually measured in watthours, while heat energy is usually measured in Btu.
  • Heat Rate is a measure of generating station thermal efficiency--generally expressed in Btu per net kilowatthour. It is computed by dividing the total Btu content of fuel burned for electricity generation by the resulting net kilowatthour generation.
  • An ohm is the unit of measurement of electrical resistance. It is the resistance of a circuit in which a potential difference of 1 volt produces a current of 1 ampere.

Source: U.S. Department of Energy / Office of Energy Information Administration

24 Hour Emergency Service • Call Us Today • (888) 822-3258 • or • Schedule Service online
24 Hour Emergency Service
(888) 822-3258
Schedule Service online
 
 
Contact Info
 
Address:  1325 Seventh St
Fennimore, WI 53809
Toll Free:  (888) 822-3258

 
For Furnace repair in Fennimore WI, like us on Facebook!
For Furnace repair in Boscobel WI, visit us on Google!
Read what your neighbors say about the Furnace repair or installation we performed near Fennimore WI on Yelp!
To schedule your Furnace installation in Lancaster WI, just email us!
Looking for Furnace repair service in Boscobel WI? - Check out our YouTube channel.
 
 
Payment Options
 
For Furnace in Fennimore WI, we accept most major credit cards.
 
We accept check for Furnace repair service provided in Boscobel WI.
We accept cash for Electrical repair service provided in Lancaster WI.
 
Apply for Financing
Send us a Message
 
Business Hours
 
Monday:  7:00am - 5:00pm
Tuesday:  7:00am - 5:00pm
Wednesday:  7:00am - 5:00pm
Thursday:  7:00am - 5:00pm
Friday:  7:00am - 5:00pm
Monday - Friday:  7:00am - 5:00pm
CALL US ANYTIME, DAY OR NIGHT. YOU WILL SPEAK TO A REAL PERSON, NOT AN ANSWERING MACHINE.
Schedule an Appointment
Home   |   Email Us   |   Schedule Service   |   Get a Quote   |   Maintenance   |   Guarantees   |   Employment   |   Tax Credits   |   Search Site
Home   |   Email Us   |   Schedule Service
Get a Quote   |   Maintenance   |   Guarantees
Employment   |   Tax Credits   |   Search Site
Google Map of H & N Plumbing, Heating, & Electrical, Inc.
Click to view full map